Dome Maintenance; Dome Maintenance; Updating/Reprogramming Dome Software; Setting The Dome Address - American Dynamics SpeedDome Ultra Installation And Service Manual

DOME MAINTENANCE

Updating/Reprogramming
Dome Software
To update or reprogram dome software:
1. Insert the chip extractor tool into the square
access hole and squeeze to extract the flash
memory chip (Figure 4-19).
CAUTION—ELECTROSTATIC
SENSITIVE DEVICE! Use a grounding
strap when handling chip.
2. Reprogram the chip or replace it with a new
chip.
3. Align the dot on the chip with the indent on
the socket, then push down on the chip to
reinsert it.
Figure 4-19.

Setting the Dome Address

Recessed at the top of the dome assembly are
three rotary switches (Figure 4-20) which enable
the dome address to be changed from 000 to 999.
Figure 4-20.

Changing Special Features

The three rotary switches (Figure 4-20) also
enable special features to be enabled or disabled.
To change enable/disable these features:
1. Enable/Disable the feature.
Remove the dome from its base, set the switches to
enable/disable the feature, then reattach the dome
to enter your settings.
918
919
920
921
922
923
2. Reset the address previously entered.
Remove the dome again to set the address
previously entered, then reattach it. The dome
should then begin its homing routine
SPEEDDOME ULTRA
4-11
SW3
SW2 SW1
MSB
LSB
0 9 0 9 0 9
Enable AGC
Disable AGC
Enable line lock
Disable line lock
Alarm contacts normally open
Alarm contacts normally closed
.
SERVICE