Appendix F: Vicon Command Summary; Supported Speeddome Ultra 8 Camera Dome Features; Vicon Command Summary - American Dynamics SpeedDome Ultra 8 Operator's Manual

Appendix F: Vicon Command Summary

This appendix summarizes the SpeedDome Ultra 8 camera dome features that are supported by
the Vicon protocol. In addition, it provides the controller commands used with the
Configuration Utility. It also provides information about tested Vicon equipment and
supported Vicon features.

Supported SpeedDome Ultra 8 Camera Dome Features

With the following exceptions, the SpeedDome Ultra 8 camera dome supports the feature set
described in this operator's guide when controlled with the Vicon protocol.
Unsupported SpeedDome Ultra 8 Camera Dome Features
•
Vicon controllers that do not support as many presets, patterns, or outputs as the
SpeedDome Ultra 8 camera dome are limited to the maximum quantities they are designed
to support.

Vicon Command Summary

The following table lists the Vicon controller key sequence to control the indicated
SpeedDome Ultra 8 camera dome functions.
If you want to ...
Set Auto Iris ON/OFF
(LED indicates Auto Iris state: ON = AUTO)
Set Auto Focus ON/OFF
(LED indicates Auto Focus state: ON = AUTO)
Goto Presets
Program Presets
Run PEEL Pattern and Repeat
Rotate dome 180° ("Flip")
Start Pattern 1-3 Definition
End Pattern Definition
Review Pattern
Accept Pattern
Run Pattern 1-3
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
121 of 140
Use ...
A/I Toggles state
Press and Hold L-Spd
A/P Toggles state
Run/Pgm switch to RUN
Enter 1-79 Enter
Run/Pgm switch to PGM
Enter 1-79 Enter
AUX5
AUX6
Run/Pgm switch to PGM
Enter 80-82 Enter
Run/Pgm switch to PGM
Enter 86 Enter
Run/Pgm switch to PGM
Enter 87 Enter
Run/Pgm switch to PGM
Enter 88 Enter
Run/Pgm switch to RUN
Enter 80-82 Enter
8200-0600-01, REV. B