Pattern Options-Fixed Or Variable Speed - American Dynamics SpeedDome Ultra 8 Operator's Manual

Pattern Options—Fixed or Variable Speed
A Pattern is a series of programmed pan/tilt/zoom dome movements. The SpeedDome Ultra 8
camera dome allows you to create fixed speed or variable speed Patterns (variable speed
Patterns are dependent on system capability).
The camera dome provides three options when configuring the system for Patterns:
Setting
Off
3
16
Use the following steps to configure the dome for Patterns:
1. Enter the Dome Configuration Menu by pressing Iris Open, Focus Far, and Zoom
Out on your controller.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Note: If a Preset or a Pattern is called by an alarm while a Sequence is running,
the Sequence will be interrupted.
Table 6. Pattern configuration options
Description
Allows programming of three fixed speed Patterns. The three
Patterns are limited to a total of 99 pan/tilt/zoom movements
(e.g., if one Pattern uses 50 movements, the remaining two
Patterns are limited to a total of 49 movements). Note: The VM1
and VM96 systems only support the OFF setting.
Allows programming of three variable speed Patterns. Each
Pattern can have up to 99 pan/tilt/zoom movements.
Allows programming of 16 variable speed Patterns. Each Pattern
can have up to 99 pan/tilt/zoom movements.
Figure 47. Dome Configuration Menu screen
DOME CONFIGURATION MENU
PAN/TILT/ZOOM/SYNC OPTS
CAMERA FUNCTIONS
ALARMS/AREAS/HOME/PRESETS/PZ
ON-SCREEN TEXT DISPLAY
LANGUAGE / PASSWORD
DOME INFORMATION
RESET TO FACTORY SETTINGS
QUIT WITHOUT SAVING
EXIT AND SAVE CHANGES
59 of 140
8200-0600-01, REV. B