Tested Vicon Equipment - American Dynamics SpeedDome Ultra 8 Operator's Manual

Setting the Auto Pan Speed
1. Press and hold A/P key.
2. Move joystick to Pan Right until the desired speed is observed on the monitor.
3. Release the A/P key.
4. Release the joystick.
Activating Auto Pan
Auto Pan allows the dome to continuously pan between the left and right scan limit settings.
To start Auto Pan, press the A/P key. If no scan limit settings are programmed, the dome pans
to the right continuously.

Tested Vicon Equipment

The following Vicon equipment has been tested with the SpeedDome Ultra 8 camera dome:
Vicon 1300 CPU Systems
•
Vicon 1400 CPU Systems
•
Vicon 1500 CPU Systems
•
Vicon VPS 324
•
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Note: If both the Left and Right scan limits are set to the same position, the
dome continuously pans to the right when Auto Pan is activated.
Note: Auto Pan will be cancelled if the operator issues a Pan, Flip, Preset, or
Pattern command.
124 of 140
8200-0600-01, REV. B