Assigning The Dome's Home Position - American Dynamics SpeedDome Ultra 8 Operator's Manual

Setting Alarm Input States
1. Select Alarms/Areas/Home/Presets/PZ from the Dome Configuration Menu.
2. Select Set Alarm States.
3. Select the appropriate input line, and then change the setting.
• Select Open if the alarm normal input state is open.
• Select Closed if the alarm normal input state is closed.
The default setting is Open.
4. Repeat step 3 for each input requiring change. When finished, continue with step 5.
5. Select Exit to return to the Alarms/Areas/Home/Presets/PZ screen.
6. When the Alarms/Areas/Home/Presets/PZ screen appears, select Exit. The Dome
Configuration Menu appears.

Assigning the Dome's Home Position

The home position is a preset or pattern that automatically runs after a designated period of
dome inactivity. Use this option if you want to keep a specific area to be under surveillance
whenever the dome is not moving.
To assign the home position, select Set Home Position from the
Alarms/Areas/Home/Presets/PZ screen. The following screen (Figure 31) appears:
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
I M P O R T A N T
When operating on Manchester networks, the dome can be programmed to respond
to any of the four available alarm inputs. However, the alarm input states cannot be
transmitted to the host controller. If transmitting the alarm input state to the host
controller is required, the alarm device must be wired directly to the host controller.
Note: In most cases, the normal input state for a dome's input should match the
contact type of the connected switch.
43 of 140
8200-0600-01, REV. B