Appendix A: Sensornet And Rs-422 Command Summary; Command Summary - American Dynamics SpeedDome Ultra 8 Operator's Manual

Appendix A: SensorNet and RS-422 Command Summary

This appendix summarizes the SensorNet and RS-422 controller commands used with the
Configuration Utility. It also provides a list of compatible controllers.

Command Summary

The following table lists the commands to operate the configuration utility when the dome is
installed in a SensorNet or RS-422 environment.
If you want to ...
Start the configuration utility.
Move the highlight bar on the active menu.
Select the highlighted item on the active menu.
Increase the value of the selected setting. For example, Red or
Blue white balance values.
Decrease the value of the selected field. For example, Red or
Blue white balance values.
Display the next choice for the setting. For example,
Maximum Zoom setting.
Display the previous choice for the setting. For example,
Maximum Zoom setting.
Save changes and exit the utility from any screen.
Manually activate or deactivate IR mode.
*
These commands not supported with MPLT with ADCC0200 or ADCC0300 controller. Refer to the appropriate
operator's manual for instructions.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
97 of 140
Use ...
Press and hold Iris Open,
press and hold a Focus
button, then press Zoom
Out*
Pan/Tilt
Focus
Zoom In
Zoom Out
Zoom In
Zoom Out
Iris Close, then Focus*
Press and hold Iris Open,
press and hold Focus
Far, then press Focus
Near*
8200-0600-01, REV. B