Appendix E: Ad Up-The-Coax (Utc) Command Summary; Command Summary - American Dynamics SpeedDome Ultra 8 Operator's Manual

Appendix E: AD Up-the-Coax (UTC) Command Summary

This appendix summarizes the AD-UTC controller commands used with the Configuration
Utility. It also provides a list of additional AD-UTC commands that can be used with the dome
and compatible controllers.

Command Summary

The following table lists the commands to operate the configuration utility when the dome is
installed in an AD-UTC environment. The keyboard must be in programming mode to perform
these functions.
If you want to ...
Start the configuration utility.
Move the highlight bar on the active menu.
Select the highlighted item on the active menu.
Increase the value of the selected setting.
For example, Red or Blue white balance values.
Decrease the value of the selected field. For example,
Red or Blue white balance values.
Display the next choice for the setting. For example,
Maximum Zoom setting.
Display the previous choice for the setting. For
example, Maximum Zoom setting.
Save changes and exit the utility from any screen.
Setting Names / Working with Passwords
When setting names or entering password information, the screen displays the available
characters in the selected languages. In these situations, the following commands are used:
If you want to ...
Move the highlight left or right in the character field.
Move the highlight up or down in the character field.
SPEEDDOME ULTRA 8 CONFIGURATION UTILITY
OPERATOR'S GUIDE
Use ...
(Function, and then Shift+Menu)
Use the Joystick
(Pan/Tilt)
(Focus Far or Focus Near)
Twist joystick clockwise
Twist joystick counter-clockwise
(Function, and then Shift+Clear)
Use ...
Joystick Left/Right
Joystick Tilt Up/Down
115 of 140
, +
F
or
(Zoom In) or
(Zoom Out) or
(Zoom In)
(Zoom Out)
, +
F
8200-0600-01, REV. B