ABB ACS880+N5350 User Manual page 86

The ID run in progress screen will automatically

display showing speed and amps.
The screen will also indicate if an ID run has been
completed before. If not, it will read "none". If a run
has been completed, it will read "Standstill".
When ID run is complete, the next screen will be
displayed.
NOTE: If the motor data is incorrect, after pressing
the display will indicate check motor parameters.
Press (exit) and check that the motor information
is correct.
3AXD50000011888
Table 12-1 Initial Start-up / Motor Data and ID Run
Local
ID run in progress...
01.01 Motor speed used
01.07 Motor current
99.14 Last ID run performed
Back
Local
ID run in progress...
01.01 Motor speed used
01.07 Motor current
99.14 Last ID run performed
√ ID run done
Exit
,
Local
Check the motor param...
The motor parameters are probably
set incorrectly. Check the parameters.
Exit
CTDD 50.0 rpm
0.00 rpm
0.00 A
None
00:00
CTDD 50.0 rpm
0.00 rpm
0.00 A
None
00:00
CTDD 0.0 rpm
00:00 Check params
Startup Assistant & Parameters 12-7