ABB ACS880+N5350 User Manual page 160

Parameter (Number)
Block Title
EMBEDDED EFB REF1 TYPE (58.26)
FIELDBUS
(Continued)
EFB REF2 TYPE (58.27)
EFB ACT1 TYPE (58.28)
3AXD50000011888
Table 12-4 Level 1 Parameter Block Definitions
Selection (Value)
Default: 0 (Auto)
Range: 0 - 5
Type and scaling are chosen automatically according to which
reference chain (see settings Torque, Speed, Frequency) the incoming
0 (ABB Drives)
reference is connected to. If the reference is not connected to any
chain, no scaling is applied (as with setting Transparent).
No scaling is applied.
2 (Transparent)
Generic reference with a scaling of 100 = 1 (ie. integer and two
2 (General)
decimals).
3 (Torque) The scaling is defined by parameter 46.03 Torque scaling.
4 (Speed) The scaling is defined by parameter 46.01 Speed scaling.
5 (Frequency) The scaling is defined by parameter 46.02 Frequency scaling.
Selects the type and scaling of reference 1 received through the
embedded fieldbus interface.
The scaled reference is displayed by 03.09 EFB reference 1.
Default: 3 (Torque)
Range: 0 - 5
Selects the type and scaling of reference 2 received through the
embedded fieldbus interface.
The scaled reference is displayed by 03.10 EFB reference 2.
For the selections, see parameter 58.26 EFB ref1 type.
Default: 0 (Auto)
Range: 0 - 6
Type/source and scaling follow the type of reference 1 selected by
parameter 58.26 EFB ref1 type. See the individual settings below for
0 (Auto)
the sources and scalings.
The value selected by parameter 58.31 EFB act1 transparent source is
sent as actual value 1. No scaling is applied (the 16-bit scaling is 1 = 1
1 (Transparent)
unit).
The value selected by parameter 58.31 EFB act1 transparent source is
sent as actual value 1 with a 16-bit scaling of 100 = 1 unit (ie. integer
2 (General)
and two decimals).
01.10 Motor torque is sent as actual value 1. The scaling is defined by
3 (Torque)
parameter 46.03 Torque scaling.
01.01 Motor speed used is sent as actual value 1. The scaling is
4 (Speed)
defined by parameter 46.01 Speed scaling.
01.06 Output frequency is sent as actual value 1. The scaling is
5 (Frequency)
defined by parameter 46.02 Frequency scaling.
Motor position is sent as actual value 1. See parameter 90.06 Motor
6 (Position)
position scaled.
Selects the type/source and scaling of actual value 1 transmitted to the
fieldbus network through the embedded fieldbus interface.
Descriptions
Startup Assistant & Parameters 12-81