ABB ACS880+N5350 User Manual page 195

Digital Inputs
Connector pitch 5 mm, wire size 2.5mm
DI1...DI6
24V logic levels: "0" < 5V, "1" > 15V
(XDI:1...XDI:6)
R : 2.0 kohm
in
Input type: NPN/PNP (DI1...DI5), NPN (DI6)
Hardware filtering: 0.04ms, digital filtering up to 8ms
DI6 (XDI:6) can alternatively be used as an input for PTC sensors
"0" > 4kohm, "1" < 1.5kohm
I
max
Start Interlock
Connector pitch 5mm, wire size 2.5mm
Input DIIL (XD24:1)
24V logic levels: "0" < 5V, "1" > 15V
R : 2.0 kohm
in
Input type: NPN/PNP
Hardware filtering: 0.04ms, digital filtering up to 8ms
Digital Inputs/
Connector pitch 5mm, wire size 2.5mm
Outputs DIO1 and
As inputs:
DIO2 (XDIO:1 and
XDIO:2)
24V logic levels: "0" < 5V, "1" > 15V
Input/output
R : 2.0 kohm
selection by
in
parameters.
Filtering: 0.25ms
DIO1 can be
configured as a
As outputs:
frequency input
(0...16 kHz with Total output current from +24VD is limited to 200mA.
hardware filtering
Figure A-1
of 4 microseconds)
for 24V level
square wave signal
(sinusoidal or other
wave form cannot
be used).
DIO2 can be
configured as a 24V
level square wave
frequency output.
See the firmware
manual, parameter
group 11.
Reference Voltage
Connector pitch 5mm, wire size 2.5mm
for Analog Inputs
10V ±1% and –10V ±1%, R
+VREF and -VREF
(XAI:4...XAI:2)
Analog Inputs AI1
Connector pitch 5mm, wire size 2.5mm
and AI2 (XAI:4...
Current input: –20...20mA, R
XAI:7)
Current/voltage
Voltage input: –10...10V, R
input selection by
jumpers.
Differential inputs, common range ±30V
Sampling interval per channel: 0.25ms
Hardware filtering: 0.25ms, adjustable digital filtering up to 8ms
Resolution: 11 bit + sign bit
Inaccuracy: 1% of full scale range
A-2 Technical Specifications
Table A-1 ACS880+N5350 Technical Data Continued
: 15mA (for DI6 5mA)
+24VD
DIOx
R
L
DIOGND
load
in
: > 200kohm
in
2
2
2
2
1...10kohm
2
: 100ohm
3AXD50000011888