ABB ACS880+N5350 User Manual page 242

G.1 ACS880 Cooling Tower Drive
G.1.1 Ethernet/IP Setup
This document will guide you through the process of setting up the ACS880 Cooling Tower Drive for monitoring and control
over Ethernet/IP using the following data in and out:
Control Word
Ref 1
Ref 2
Accel Time
This guide assumes that the basic drive setup has already been done. This includes setting the Language & Units, entering
Motor Data and performing an ID Run.
Once this basic drive setup has been done, the following parameters will need to be set:
Group 76: CTD Motor Control
76.03 Operating Mode = FIELDBUS
96.02 Pass Code = 13 Fieldbus
Group 50: Fieldbus Adapter
50.01 FBA A Enable = Option Slot 1
50.02 FBA A Comm Loss Function = Warning
50.03 FBA A Comm Loss Timeout = 3sec
50.04 FBA A ref1 Type = Speed
50.08 FBA A Act1 Transparent source = Torque
50.09 FBA A SW Transparent Source = 6.11[16]
Group 51: FBA A Settings (Ethernet Adapter Setup)
51.01 FBA A Type = EtherNet
51.02 Protocol/Profile = EIP T16 (102)
51.03 Comm Rate = Auto
51.04 IP Configuration = STATIC
51.05 IP Address
51.06 IP Address
51.07 IP Address
51.08 IP Address
51.09 Subnet CIDR = 24
51.10 GW Address
51.11 GW Address
51.12 GW Address
51.13 GW Address
3AXD50000011888
This is the top option slot on the drive. Adapter can go in any slot
This setting determines what the drive does when comms are lost
This time is added to the time in 51.20 before issuing a fault/warning
Status Word sent back to the PLC will be par 6.11 Main Status Word
Automatically adjusts to 10 or 100Mbit/s network speed
ex. 192
ex. 168
ex. 3
ex. 88
Shorthand for 255.255.255.0
Leave at default (zero) if not used
Leave at default (zero) if not used
Leave at default (zero) if not used
Leave at default (zero) if not used
Appendix G
Ethernet/IP Setup
Status Word
Actual Speed (rpm)
% Motor Torque x 100
Motor Current (1=1Amp)
DC Bus Volts x 10
Ethernet/IP Setup G-1