Table of Contents
Advertisement
Parameter (Number)
Block Title
WARNINGS
EVENT WORD 1 BIT 15
AND FAULTS
CODE (04.71)
(Continued)
EVENT WORD 1 BIT 15 AUX
CODE (04.72)
DIAGNOSTICS
Various run-time-type counters and measurements related to drive maintenance. All parameters in this
group are read-only unless otherwise noted.
ON-TIME COUNTER (05.01)
RUN-TIME COUNTER (05.02)
FAN ON-TIME COUNTER
(05.04)
INVERTER TEMPERATURE
(05.11)
DIAGNOSTIC WORD 3 (05.22) Default: Read Only
MAIN FAN SERVICE
COUNTER (05.41)
3AXD50000011888
Table 12-4 Level 1 Parameter Block Definitions
Selection (Value)
Default: 0000h
Range: 0000h - FFFFh
Code of event. Selects the hexadecimal code of an event (warning,
fault or pure event) whose status is shown as bit 15 of 04.40 Event
word 1. The event codes are listed in chapter Fault tracing.
Default: 0000 0000h
Range: 0000 0000h - FFFF FFFFh
Code of warning, fault or pure event. Specifies an auxiliary code for
the event selected by the previous parameter. The selected event is
indicated by the event word only if its auxiliary code matches the value
of this parameter.
With a value of 0000 0000h, the event word will indicate the event
regardless of the auxiliary code.
Default: Read Only
Range: 0 - 65535 d
On-time counter - The counter runs when the drive is powered.
Default: Read Only
Range: 0 - 65535 d
Motor run-time counter - The counter runs when the inverter
modulates.
Default: Read Only
Range: 0 - 65535 d
Cooling fan run-time counter - Running time of the drive cooling fan.
Can be reset from the control panel by keeping Reset depressed for
over 3 sec.
Default: Read Only
Range: -40.0 to +160.0 %
Drive temperature in percent - Estimated drive temperature in percent
of fault limit. The fault limit varies according to the type of the drive.
0.0% = 0°C (32°F); 100.0% = Fault limit
Range: 0000h - FFFFh
Diagnostic word 3.
Bit
0 - 10
11
12 - 15
Default: Read Only
Range: 0 to 150%
Main cooling fan age. Displays the age of the main cooling fan as a
percentage of its estimated lifetime. The estimate is based on the duty,
operating conditions and other operating parameters of the fan. When
the counter reaches 100%, a warning (A8C0 Fan service counter) is
generated.
Can be reset from the control panel by keeping Reset depressed for
over 3 seconds.
Descriptions
Name
Value
Reserved
Fan command 1 = Drive fan is rotating above idle speed.
Reserved
Startup Assistant & Parameters 12-25
Advertisement
Table of Contents
