Displaying Setting And Measured Values; Canceling Autoadapt - Dräger Carina Instructions For Use Manual

Operation

Canceling AutoAdapt

1 Press the (A) key three times. Menu 4 is set.
2 Press the key for Aut.Adapt (B). Select Off by
turning the rotary knob (F) and push to confirm.

Displaying setting and measured values

Prerequisite: Carina is in ventilation mode.
A
1 Press the Select Menu (A) key.
2 Press the Values (B) key.
D
The device shows the following on the screen:
– Bar graph for pressure (C)
– Set values (D)
– Measured values (E)
72
B
C
E
The device ventilates with the previous ventilation
parameters.
Measured values depending on the valve in use
Valve Volume measured values
LeakV MVi, VTi, MVleak
ExpV MV, VT, - -
1) MVleak always shows the total leakage, consisting of pa-
tient leakage and valve leakage.
2) MVleak is always at - - because no leakage is measured
and compensated.
Instructions for use Carina SW 3.2n
1)
2)