ASCOM IP-DECT Base Station Installation And Operation Manual page 58

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
Figure 54.
Figure 28. RFP Details
Figure 55.
Port
Status
Description
RFPI
SW Version
Hardware
Boot
Connected Time
Cable Delay
Tx Error
Rx Error
BER SC0
SER SC1
Note: If BER differs from 0, inspect the RFP cable.
3 The following actions are available:
• Click "OK" to save your settings and close the pop-up window.
• Click "Cancel" to close the pop-up window.
• Click "Refresh" to update the information.
• Click "Reset" to reset the RFP.
2007-06-18/ Ver. E
The port used in the IPBL.
Current status of the DECT base station connected to the IPBL.
A short description to help identify the DECT base station.
Identity number.
The current software version.
The hardware version.
RFP boot version.
The elapsed time since the RFP connected to the IPBL.
The delay caused by the cable.
The number of transmitting errors.
The number of receiving errors.
Bit Error Rate SC0. Normal value: 0.
Bit Error Rate SC1. Normal value: 0.
TD 92372GB
53