Configure Ldap Replicator; Check Ldap Replicator/Server Status - ASCOM IP-DECT Base Station Installation And Operation Manual
Hide thumbs
Also See for IP-DECT Base Station:
- Brochure (8 pages) ,
- Information (32 pages) ,
- Installation manual (38 pages)
Table of Contents
Advertisement
Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
3
Enter a password in the Password text field.
4
Mark the Write Access check box.
5
Click "OK".
Figure 40.
Figure 23. Setting LDAP User Name and Password
7.4.2
Configure LDAP Replicator
The slaves are normally setup as LDAP replicators.
1
Select LDAP > Replicator.
2
Mark the Enable check-box.
3
Enter the IP address to the LDAP server in the Server text field.
4
Enter the IP address to the alternative LDAP server in the Alt. Server text field.
Note: If this IPBS/IPBL is configured as a standby LDAP server, enter "0.0.0.0" in the
Alt. Server text field.
5
Enter the LDAP User name and Password in the User and Password text fields.
6
Click "OK".
7.4.3
Check LDAP Replicator/Server status
1
Select LDAP.
2
Select Replicator/Status or Server/Status.
2007-06-18/ Ver. E
TD 92372GB
40
Advertisement
Table of Contents
Need help?
Do you have a question about the IP-DECT Base Station and is the answer not in the manual?
Questions and answers