Configure The Slave - ASCOM IP-DECT Base Station Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
8 Select supplementary services, see
page 44.
9 Assign PARI, see
10 Configure air synchronization, see
46.
11 Enter IMS IP address, see
12 Enter the Time Server address, see
13 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server. Alternative LDAP server must not be entered. Check the Enable check
box, see
14 Reset in order to make the configuration changes take effect, see
page 60.
If problem to access the standby master from a certain PC after the reset;
• Open a command window in windows by selecting Start > Run and enter
"cmd" in the Open: text field.
• Enter the following commands
• Restart the WEB browser.
6.5

Configure the Slave

This section describes how to configure the Slave. Each configuration step is briefly
described in the step list below, for more detailed information see the corresponding
subsection in
Note: When one slave is configured, the configuration can be saved and uploaded to the
other slaves in the system.
1 Determine the address and access the GUI, see
2 Change the default password, see
3 Set DHCP mode to "Client", see
4 Configure LDAP replicator, enter the IP address, user name and password to the
LDAP server and the alternative LDAP server. Check the Enable check box, see
Configure LDAP Replicator
5 Enter the system user name and password, this must be the same user name and
password as in the Master, see
With LDAP replication enabled, the password will be verified against the master. If
the password is wrong a single dot will appear in the text field.
6 Set the mode to Slave, see
7 Enter master and standby master IP addresses, see
Master and the Standby Master
8 Configure air synchronization, see
46.
9 Enter the Time Server address, see
10 Reset in order to make the configuration changes take effect, see
page 60.
11 Save the configuration of the Slave, see
2007-06-18/ Ver. E
7.5.17 PARI on page 45.
7.5.19 Configure Messaging
7.4.2 Configure LDAP Replicator
arp -d (Delete the arp cache)
nbtstat -R (Empty the nbtstat cache)
7 Operation on page 31.
on page 40.
7.1.1 Change User Name and Password
7.5.14 Select Mode
7.5.13 Configure Supplementary Services
7.5.20 Configure Air Synchronization
on page 46.
7.1.5 Configure the NTP Settings
on page 40.
6.2 Access the GUI
6.2.2 Change the Default Password
7.2.3 Dynamic IP address via DHCP
on page 44.
7.5.16 Enter IP Address to the
on page 45.
7.5.20 Configure Air Synchronization
7.1.5 Configure the NTP Settings
7.9 Backup on page 56.
TD 92372GB
on
on page
on page 34.
7.12 Reset on
on page 25.
on page 27.
on page 38.
7.4.2
on page 32.
on page
on page 34.
7.12 Reset on
29