Add Users; Anonymous Registration; Add Users In The Ip-Dect System - ASCOM IP-DECT Base Station Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
Configure the rest of the IPBS/IPBLs following the steps below:
Note: Uploading the same configuration to all slaves can only be done if the DHCP is set
to client.
1 Determine the address.
2 Select Update > Config and browse to the previously saved configuration. Click
"OK".
3 Reset in order to make the configuration changes take effect, see
page 60.
4 Repeat step 1 to 3 for all Slaves.
6.6

Add Users

This section describes how to add users to the IP-DECT system. There are two ways to
register handsets:
• Using the handset to automatically associate the IPEI number to a user, see

Anonymous Registration

• Entering the IPEI number of the handset manually, see
page 31.
6.6.1 Anonymous Registration
The IPEI, which is the unique identification number of the handset, can be assigned
automatically to a user. This is used to avoid having to enter the IPEI number manually.

Add users in the IP-DECT System

1 Under the Administration menu, select Users.
2 Click "New".
3 Enter the following information in the corresponding text fields, leave the IPEI and
the Auth. Code text fields empty:
• Long Name - The name of the user, need to be unique throughout the system.
This is the name presented in a called party´s display, unless this is configured in
the IP-PBX.
• Name - The user name.
• Number - The phone number extension, need to be unique throughout the
system.
• Password - Optional, is used for registration towards the gatekeeper.
• Display Text - Will be showed in the handset display when the phone is idle.
4 Click "OK".
5 Repeat step 2 to 4 for all users.
2007-06-18/ Ver. E
on page 30.
TD 92372GB
7.12 Reset
6.6.1
6.6.2 Individual Registration
on
on
30