Configure The Master; Change The Default Password - ASCOM IP-DECT Base Station Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
Figure 33.
Figure 19. Determine the IP address
4 Enter http://xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the determined IP address) in
the browser address field to access the GUI.
5 After the first startup of the IPBS/IPBL the DHCP mode should be changed from
"automatic" to either "client" or "off", see
6.2.2

Change the Default Password

1 Enter the IP address determined in
browser address field.
2 Select General > Admin.
3 Enter user name and password in the dialogue box.
Default user name is: admin.
Default password is: changeme.
4 Enter a user name in the User Name text field.
5 Enter a password in the Password text field. Repeat the password in the second text
field.
6 Click "OK".
6.3

Configure the Master

This section describes how to configure the Master. Each configuration step is briefly
described in the step list below. For more detailed information see the corresponding
subsection in
1 Determine the address and access the GUI, see
2 Change the default password, see
3 Configure LDAP user name and password, mark the Write Access check box, see
7.4.1 Configure LDAP Server
4 Set a static IP address and set DHCP to off,
37.
2007-06-18/ Ver. E
7 Operation on page 31.
on page 39.
7.2.1 Set DHCP Mode
6.2.1 Determine the IP Address
6.2 Access the GUI
6.2.2 Change the Default Password
see7.2.2 Set a Static IP Address
TD 92372GB
on page 37.
in the web
on page 25.
on page 27.
on page
27