Ac-Adapter - ASCOM IP-DECT Base Station Installation And Operation Manual

Installation and Operation Manual
IP-DECT Base Station & IP-DECT Gateway
Software
The software in the BS3x0 can be updated by downloading new software without
disconnecting the equipment. The new software is stored in flash memory. See
Update on page 56 for information.
Connectors
• Two 8-pin RJ45 modular jacks for data and powering
• A 6-pin RJ12 modular jack for factory testing
LEDs
Status of LED1 (lower LED)
Steady Green
Status of LED2 (upper LED)
Not lit
Flashing green
Steady green
Flashing amber
Steady amber
2.4

AC-adapter

The AC-adapter is used to power a base station locally.
Note: The maximum length of cable from adapter must not exceed 10 meters.
Versions (different type of mains plug)
BSX-0013
BSX-0014
BSX-0015
BSX-0016
IMPORTANT: If local power supply is used for the RFPs, the EPP cable pair must not be
2007-06-18/ Ver. E
Description
Power LED
Description
Base station operational and no traffic on the
base station.
All 8 speech channels are in use.
Base station operational and traffic on the base
station.
Software is being downloaded to the base station
Base station is OK, but not available (self-test, not
initialized,no communication with IPBL)
For European countries except U.K.
For U.K.
For US/Canada
For Australia
connected.
TD 92372GB
7.10
8