2.9 Using the mini-jack connector of the RCU
Connecting a cable with the mini-jack connector will reset the broadcast address of the RCU to its
default value '0'.
How to use the mini-jack connector
1.
Connect a cable with the mini-jack connector (reference 2 Image 2-8) of the RCU.
2.
Connect the other end of the cable with the mini-jack input of the projector.
Image 2-8
Note: While the mini-jack cable is connected, the IR beam of the RCU is switched off.
Pulse Remote Control Unit
R5906112 /09
UDX series
33