System With Devices Without Rolling Code; Synchronizing The Rolling Codes; Reprogramming A Single Homelink Button - Maserati Levante Owner's Manual

Understanding the Vehicle
• Release immediately the Homelink
button you want to program.
• Continue holding the hand-held
transmitter button until the indicator
light starts flashing quickly; then
2
release the button.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
NOTE:
The distance necessary between the
portable hand-held transmitter and
®
the HomeLink in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
several times. Upon every attempt,
keep the setting position for at least
15 seconds before trying again.

Synchronizing the Rolling Codes

At the end of the previously-described
programming, if the HomeLink
has been programmed for a rolling
code system, it will be necessary to
synchronize it to ensure its correct
operation.
• Locate the "LEARN" or "TRAINING"
setting button of the opening motor.
Firmly press it and then release it. On
some garage door openers/devices
there may be a light that blinks when
56
®
the garage door opener/device is in
the LEARN/TRAIN mode.
NOTE:
You have 30 seconds to initiate the
next step after the setting button has
been pressed.
• Return to the vehicle and press the
programmed HomeLink
two seconds and then release it.
®
system.
• Repeat this operation a second time.
If the garage door opening device
activates, the programming/
synchronization phase is complete.
NOTE:
If the garage door opening device
does not activate, press the button
a third time for two seconds and
then release it to complete the
programming/synchronization phase.
• To program the remaining two
HomeLink
®
step for each remaining button. DO
NOT erase the channels.
Reprogramming a Single HomeLink
Button
To reprogram a channel that has been
previously trained, follow these steps:
• Place the ignition device to the RUN
position without starting the engine.
• Press and hold the desired HomeLink
button.
® button for
®
buttons, repeat the same
®
®
• Without releasing the button
proceed with "Programming the
hand-held transmitters" from second
step and follow all remaining steps.
System with Devices Without
Rolling Code
Programming the Hand-held
Transmitters Manufactured before
1995
• Turn the ignition device to the RUN
position without starting the engine.
• Place the hand-held transmitter 1
to 3 inches (5 to 30 cm) away from
the HomeLink ® button you wish to
program.
• Simultaneously press and hold both
buttons until the indicator light starts
flashing quickly; then release both
buttons.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink ®
NOTE:
The distance necessary between the
portable hand-held transmitter and
®
the HomeLink in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
several times. Upon every attempt,
system.