• Place the jack near the wheel to be
changed as illustrated. Make sure
that the head of the jack is correctly
inserted in one of the slots 1 or 2
under the longitudinal member.
WARNING!
•
Never position yourself under a
jacked vehicle.
•
A jack in the wrong position could
cause the vehicle to fall. Severe risk
to the operator's safety and damage
to the vehicle could occur.
•
Never use the jack to carry out
maintenance or repairs under the
vehicle.
• Insert the extension levers in the jack.
• Turn clockwise the extension lever
of the jack until the wheel is raised a
few inches off the ground.
In an Emergency
• Completely unscrew the five bolts
and remove the wheel.
• Make sure that the contact surfaces
between spare wheel and hub are
clean and free of impurities.
• Fit the compact spare wheel with the
valve stem side out and secure it with
the five bolts previously removed,
without tightening them.
• Remove from the compressor case
the inflation hose and the cable with
a plug for the power outlet.
• Unscrew the valve cap of the compact
spare wheel and screw the fitting of
the inflation hose onto the valve.
• Insert the plug inside one of the
available power outlets fitted in the
trunk or passenger compartment.
• Set the ignition device on ACC or
RUN position.
• Turn the compressor on by pressing
the switch.
7
279