Table of Contents
Advertisement
Before Starting
B. Sunshade fully rolled down
("DOWN" position) and Window
closed ("UP" position)
3
• Pulling the control up to 1 or
2 detent: the sunshade unrolls
completely and the window stays
closed.
• Pressing the control to 1 or 2 detent:
the window opens partially or
completely and the sunshade remains
rolled.
80
C. Sunshade fully rolled down
("DOWN" position) and Window
completely open ("DOWN" position)
• Pulling the control to 1 or 2 detent:
the window closes partially or
completely and the sunshade remains
rolled.
• Pressing the control to 1 or 2 detent:
no action ("NOP").
Teaching Cycle
After battery disconnection, the
following teaching cycle is required to
store the limit positions the sunshades.
Use the controls on the rear doors to
move the sunshades.
• With glass closed, lift rear sunshade
control on driver side for a few
seconds. It is not necessary that the
sunshade reaches its upper limit.
• Reverse the sunshade movement by
pressing the control downwards.
Once the lower limit is reached, press
and hold the control for at least 10
seconds. This action allows setting
the control unit in initialisation
status.
• Release the movement command.
• Within maximum 15 seconds:
- Press once the control downwards
(first or second detent). In this way
the control unit stores the lower
limit position. During this operation
a slight click of the sunshade motor
that switches to mechanical lock
condition can be heard.
- Lift the control and hold it up until
the sunshade completes its upstroke
and reaches the car body pillar, fully
home. Once the upper limit stop is
reached, the sunshade will move
downwards for approx. 0.08-0.12 in
(2-3 mm) and the control unit will
Advertisement
Table of Contents
