Table of Contents
Advertisement
In an Emergency
• When the pressure indicated by the
gauge reaches the recommended
level of 350 kPa - 51 psi - 3.5 bar
(
: chapter "Tire Inflation
Pressure" in section "Technical
Specifications"), stop the compressor
by pressing switch again and screw
the cap on the compact spare wheel
valve.
WARNING!
•
In order to obtain a more accurate
reading, the compressor should be
7
switched off when checking the tire
pressure of the compact spare wheel
on the pressure gauge.
•
Do not run the compressor for more
than 20 minutes: there is a risk it
could overheat. Also, prolonged
power absorption may discharge the
280
battery, subsequently preventing the
engine from starting.
•
The compressor has been designed
exclusively to inflate compact spare
wheels; do not use it to inflate air
mattresses, dinghies etc.
• Turn counterclockwise the extension
lever of the jack to lower the vehicle
and remove the jack.
• Fully tighten the bolts, alternately
tightening diametrically opposite.
WARNING!
•
FOR ALUMINIUM SPARE WHEEL
Observe the tightening torque for
the bolts securing the compact spare
wheel (72 ± 7 lbf·ft/ 98 ± 10 Nm).
•
FOR STEEL SPARE WHEEL Observe
the tightening torque for the bolts
securing the compact spare wheel
(63 ± 7 lbf·ft/ 86 ± 10 Nm).
•
Bolts must be tightened only after
vehicle is back to ground, so as
to prevent it from falling down
due to the force exerted for bolt
tightening. Failure to comply with
this recommendation can cause
operator injuries.
WARNING!
•
The compact spare wheel is narrower
than standard wheels and must
only be used to travel the distance
required to reach a service station,
where the punctured tire can be
repaired or replaced.
•
Do not exceed a maximum speed
of 50 MPH (80 km/h) when using
the compact spare wheel; when
this limit is exceeded, the stability,
road holding and braking of the
vehicle will be compromised. Avoid
accelerating to full speed, heavy
braking and fast cornering.
•
The compact spare wheel must
be inflated to the recommended
tire pressure (
: chapter "Tire
Inflation Pressure" in section
"Technical Specifications").
Advertisement
Table of Contents
