Fog Lights; Manual Headlights - Maserati Levante Owner's Manual

Dashboard Instruments and Controls
(programmable) when leaving your
vehicle in an unlit area. To activate
automatically the delay function with
the light switch in "AUTO" position,
place the ignition device in the OFF or
ACC position while the headlights are
still on.
The delay interval begins when the
lights switch is turned off (position
"0"), on the vehicles of United States
market, and/or when the ignition
device is placed in the OFF or ACC
position on vehicles of Canadian
4
market. If you turn the headlights or
position lights on, or place the ignition
device in RUN, the system will cancel
the delay.
If you turn the headlights off ("0"
position) before the ignition, they will
turn off in the normal mode.
To activate manually the delay
function the headlights must be on
before place the ignition device in the
OFF or ACC position and the light
switch in "AUTO" position.
NOTE:
• To activate this function the lights
must be turned off ("0" position),
on vehicles of united States market
only, and/or the light switch must be
turned in "AUTO" position within 45
140
seconds of placing the ignition device
in the OFF or ACC position.
• Once the delay function is active, any
additional shifting of the light switch
will cancel the function.
• The headlight delay time is
programmable using the MIA system,
see "Functions of Settings Menu
on MIA" in section "Dashboard
Instruments and Controls".
• If the low beam bulbs/LEDs are active
due to "Headlights with Wipers",
then the headlamps delay function
will not be activated when the
ignition device is set in OFF position.

Manual Headlights

Turning the light switch in position
turns on the low beam together
with the position lights, the side
markers and the license plate lights
regardless of the ignition device state
and the "DAY" or "NIGHT" mode
detected by the twilight sensor (see
table in "Light Switch" paragraph of
this chapter).
The related telltale will display
on the instrument cluster.

Fog Lights

NOTE:
The front fog lights can only be
switched on if the position lights (the
picture shows that of United States
market) are switched on
possible to turn on the rear fog lights
only if the low beam lights (
the front fog lights ( ) are on.
The front and rear fog lights switch is
built into the light switch.
The front and rear fog lights turn on
and off in the following order:
• press the lights switch once to turn
on the front fog lights;
• press the lights switch a second time
to turn on the rear fog lights (front
fog lights will stay on);
• from this condition, press the lights
switch again to turn off the rear fog
lights (front fog lights will stay on);
• press the lights switch again to turn
off the front fog lights.
. It is
) or