Table of Contents
Advertisement
position enabling to open the wiper
arms and change the blades.
It is possible to use the "MIST"
position for a maximum of 3 times
within two minutes, corresponding to
different three blades positions on the
windshield. When completed, bring
the ignition device in RUN: the arms
will reposition. If necessary move the
multifunction lever to other required
operating positions.
To change the wiper blade on rear
window of liftgate, simply lift the
wiper arm to detach it from window
(see paragraph "Wiper Maintenance
and Blades Replacement" in chapter
"Maintenance Procedures" of section
"Maintenance and Care").
WARNING!
Operate or service the windshield
wiper blades without deactivating
the wipers ("OFF" position), leaving
the ignition device in RUN can be
dangerous for the operator since the
rain sensor may suddenly activate the
wipers. Always use "Service" position
for any intervention on the windshield
wiper blades.
Windshield Washers and
Headlight Washers
To use the washer on the windshield,
push the end of the multifunction
lever inward (toward the steering
column) and hold it as long as washer
spray is desired.
If you activate the washer while the
windshield wiper control is in the
automatic intermittent range, the
wipers will operate for two wipe
cycles after releasing the lever and
then resume the previously-selected
intermittent interval.
If you activate the washer while the
windshield wiper is turned off ("OFF"
position) the wipers will operate for
three wipe cycles and then turn off.
Dashboard Instruments and Controls
WARNING!
•
Do not start the windshield washer
during the cold months until the
windshield has warmed up. If it has
not warmed up, the liquid could
freeze on the glass and block your
view.
•
Sudden loss of visibility through
the windshield could lead to a
collision. You might not see other
vehicles or other obstacles. To avoid
sudden icing of the windshield
during freezing weather, warm the
windshield with the defroster before
and during windshield washer use.
Headlight Washers (if provided)
The multifunction lever also operates
the headlight washers when the
ignition device is in RUN position and
the headlights are turned on.
4
145
Advertisement
Table of Contents
