Table of Contents
Advertisement
Understanding the Vehicle
WARNING!
After refitting the trunk cover, make
sure that the lower ends of the
inner part have properly engaged in
2
their guides. If cover is not properly
positioned and fastened, in case
of unexpected stop or collision it
could move and seriously injure the
passengers in the rear seats.
Cargo Area Extension
The following procedure is aimed
at obtaining the maximum possible
extension of the cargo area, and it can
be only a partial extension if you carry
out only a few of the listed operations.
• Remove the trunk cover as indicated
under "Trunk Compartment Cover"
in this chapter.
• Completely lower the side head
restraints of rear seats (
chapter "Head Restraints" in section
"Safety").
• On the long part (60) of the backrest
place the central head restraint in the
position of use indicated on the label
applied on the fixed side windows
(
: chapter "Head Restraints" in
section "Safety").
• Completely fold down the rear
seatback by lifting the lever to
position 1 and hold it up.
50
• Release the lever when seatback is
against the seat: the control cable
will click into place and lock.
• In this position, push down on the
seatback of the long part (60): the
control cable will click into place and
lock.
:
Now that seatbacks are folded down,
trunk floor and the back panels of
seatbacks will form a larger flat floor.
CAUTION!
Seatback rear panel is not suitable to
support heavy loads and metal objects
with protruding elements that might
scratch its surface. If necessary, protect
the seatback rear panel surface using
rigid panels.
Installing the Cargo Net for
Cargo Area
The Cargo Net can be installed to two
positions depending on the current
extension of the cargo area. When
only the trunk cover is removed (see
previous paragraph), while backrests
are still vertical, the Cargo Net must
be installed immediately behind them
(position A).
While, in case also backrests were
folded down, the Cargo Net must be
Advertisement
Table of Contents
