Table of Contents
Advertisement
Before Starting
control at the maximum speed. Do not
activate recirculation.
Set the Position of Maximum Power
Liftgate Opening
The maximum opening position of
the liftgate can be modified using
the previously described buttons
on the outer left edge of the trunk
3
compartment.
1.
Activate the liftgate and stop it
in the new maximum opening
position to be set, by pressing the
upper
button.
2.
Press the upper
buttons and keep it pressed for 3
seconds.
3.
Release the button (pressed in
the previous point). Upon the
following opening controls, the
liftgate will stop in the stored
position.
If you want to reset the maximum
possible opening position of the
liftgate, proceed as described below
starting from the previously set
opening position.
1.
Manually push the liftgate to
the maximum possible opening
position.
2.
Repeat the previously performed
steps 2 and 3.
86
Power Liftgate Automatic Safe
Movement
Power liftgate safe opening and
closing is ensured by a protection
system able to stop its movement
when an obstacle is detected along the
path: when opening or closing, it stops
automatically and then slightly moves
back.
Along the upper outer edges, the
vehicle can be equipped with anti-
pinch protection sensors. These sensors
stop the automatic closing stroke and
partly open the power liftgate when
or lower
a pressure is carried out, also slight,
within their range shown in the figure.
After the closing command, when
power liftgate starts closing, all the
indicators will blink to warn anyone
within range.
Apart from activating indicators
blinking when power liftgate is
operated, it is also possible to activate
a sound warning by selecting the
relevant function within MIA user
settings (see "Functions of Settings
Menu on MIA" in section "Dashboard
Instruments and Controls").
When power liftgate edge reaches the
car body, the motor locking the latch is
activated automatically.
If necessary, the power liftgate can
also be opened or closed manually
using the handles indicated in the
picture. This operation could be
required when the liftgate remains
open for a long period of time.
NOTE:
Frequent activations of the anti-pinch
protection function may disable the
automatic movement of the power
liftgate. To reactivate this function,
perform a reset cycle by carrying out a
Advertisement
Table of Contents
