High Beams And Flashing - Maserati Levante Owner's Manual

Dashboard Instruments and Controls
To activate lane change function, tap
the lever up or down once, without
4
moving beyond the detent. The turn
signals (right or left) will flash three
times then automatically turn off.
This function is useful when
overtaking or changing lanes.
NOTE:
• If either light remains on and does
not flash, or flashes at a fast rate,
check for a defective outside light. If
an indicator on the instrument cluster
fails while moving the lever, then the
turn indicator is probably defective.
• The message that a turn signal is on
will appear in the instrument cluster
and a continuous chime will sound if
the vehicle is driven more than 1 mile
(1.6 km) with either turn signal on.

High Beams and Flashing

To switch on the high beams with
the light switch in
142
position, shift the multifunction lever
onward.
The blue telltale
on the tachometer.
By pulling the lever backward (toward
the steering wheel) you switch off the
high beams and switch on the low
beams.
You can signal another vehicle with
your headlights by lightly pulling the
multifunction lever toward you. This
or "AUTO"
will turn on the high beams headlights
until the lever is released.
will illuminate
Flashing occurs also with lights off
(lights switch in position "0") if the
ignition device is RUN position.
CAUTION!
The high beams can only be switched
on manually by pushing the
multifunction lever forward.
WARNING!
If the high beams are activated, they
will turn on automatically every
time the low beams are switched on
either manually or automatically. We
recommend therefore that you switch
them off when they are no longer
necessary and every time the twilight
sensor deactivates the external lights.