Start&Stop Function Disabling - Maserati Levante Owner's Manual

Starting and Driving
driver is present and does not allow
automatic restarting of the engine if
one of the following maneuvers is
being performed while in "AutoStop"
condition:
• The driver unbuckles his/her seat belt
and releases the brake pedal.
• The driver opens the door and
releases the brake pedal.
• The driver unbuckles the seat belt
and opens the door.
• The driver opens the hood.
All the above-mentioned conditions
deactive the Start&Stop function
(the "AutoStart" is deactivated and
the engine remains off) and the
5
transmission shift automatically in P
(Park).
The telltale will flash to indicate
the Start&Stop function disabling. To
restart the engine it is necessary to
press the brake pedal and push the
START/STOP button.
Move the shift lever to D (Drive) to
drive away.
170
WARNING!
• Even when the vehicle is stopped
in the "Stop (AutoStop)" phase, the
driver is responsible for the vehicle
and the occupants and shall take
care of what happens inside and
outside the vehicle.
• Even when the vehicle is stopped
within the "Stop (AutoStop)" phase,
the vehicle driver is responsible for
the vehicle, the vehicle's occupants
and the vehicle's surrounding area.
Never leave the vehicle unattended
with the engine running; doing so
poses a risk of danger. It is a good
practice to always ensure to set
the parking brake and place the
transmission gear selector lever
into the P (Park) position, thereby
ensuring the vehicle will not move,
when performing any vehicle
checks, maintenance and/or service
procedures on the vehicle.
Start&Stop Function Disabling
Start&Stop enabled is the default
status.
Under certain driving conditions,
when frequent stops and restarts of
the engine may become annoying, it
is possible to turn off the Start&Stop
function in different ways.
When the Start&Stop function is
turned off in the all following ways,
in addition to the related message
the amber indicator on the TFT
display indicated in the picture will
turn on.
• Use the controls located on the
right side of the steering wheel (see
instructions in chapter "TFT Display
Setting and Menu Overview" in
section "Dashboard Instruments
and Controls") and hold the
multifunction switch to change
the status of the function.
It is possible to disable the Start&Stop
via the MIA in the following ways.
NOTE:
The highlighted and yellow soft-key
indicates the disabled status of
Start&Stop system and vice versa.