Table of Contents
Advertisement
Understanding the Vehicle
Memorize the Driver's
Seat Position
This function allows the driver to
store up to two different memory
2
profiles for easy recall through a
memory switch. Each memory profile
contains desired position settings for
the driver seat, external side mirrors,
adjustable pedals (
telescopic steering column and a set of
programmed radio stations.
Your key fob can also be set to recall
the same positions by pressing the
button.
NOTE:
• Only one key fob can be linked to
each of the memory positions.
• "Passive Entry" door handles cannot
be linked to the memory function.
Use either the memory recall switch
or the key fob (if linked to the
memory function) to recall memory
positions 1 or 2.
The memory seat switch is located
on the driver's door trim panel. The
switch consists of three buttons:
• The "S" (SET) button, which is used to
activate the memory save function.
• The "1" and "2" buttons which
are used to recall either of two
programmed memory profiles.
18
), power tilt and
Memory Profiles Setting
NOTE:
Saving a new memory profile will
erase an existing profile from memory.
To create a new memory profile,
perform the following:
• Cycle the ignition device to the ACC
or RUN position.
• Adjust all memory profile settings
to desired preferences (i.e., seat,
side mirrors, adjustable pedals (
power tilt and telescopic steering
column, and radio station presets).
• Press and release the "S" button on
the memory switch.
• Within 5 seconds, press and release
the memory button "1" or "2".
• Check on the instrument cluster for
the positive response of the actions
"Memory 1 (or 2) profile set".
After these steps, the profile set will
be memorized in the selected position.
NOTE:
Memory profiles can be set without
the vehicle in P (Park), but the vehicle
must be in P (Park) to recall a memory
profile.
Pairing Remote Keyless Entry
Transmitter to Seats Memory
Your key fob can be programmed
to recall one of two programmed
memory profiles by pressing the
button on the key fob.
NOTE:
This function can be enabled or
disabled using the MIA system, refer to
"Functions of Setting Menu on MIA" in
section "Dashboard Instruments and
Controls" for further information.
To program your key fobs, perform the
),
following actions:
• Cycle the ignition device to the RUN
position.
• Move the seat and/or the other
adjustable devices in the position
that you wish to memorize, or recall
a previously memorized profile,
pressing the corresponding memory
button "1" or "2".
• Cycle the ignition device to the OFF
position.
Advertisement
Table of Contents
