Display Messages - Felix printers Pro 2 Touch Quick Start Manual

Chapter 5: Software, maintenance, support

5.5 Display messages

Flow detection
The flow detection system is triggered – the printer moves to it's idle position waiting for user action.
The flow detection system is triggered when there is no more filament going through the extruder or when the filament is not extruding at the
expected rate. Go to www.felixprinters.com/support
Z-sensor error
The z-sensor triggered message should appear only when the tip of the hot-end touches the print bed.
If the message is displayed continuously go to
Sensor error
Extruder: the sensor is defect or not connected properly. Please check if the connector is placed correctly and is clean on the inside.
Heated bed: please check if the bed is placed properly on all 3 magnet points.
Heater error
Extruder: the heater or sensor are giving improper values. Please check if the connector is placed correctly and is clean on the inside.
Heated bed: please check if the contact pins underneath the print bed are ok.
Leveling failed
The z-sensor triggered falsely during the leveling routine or measured probe values are out of their boundaries.
Go to www.felixprinters.com/support
FELIXprinters Quick Start Manual for the FELIX Pro 2 Touch FELIXprinters Quick Start Manual for the FELIX Pro 2 Touch
to learn more.
www.felixprinters.com/support
and look for the 'z-sensor triggered' topic.
to find out how to solve this issue.
Page 26