Table of Contents
Advertisement
12.2 Dust cleaners
Filament attracts a lot of dust and small particles. Make sure the filament enters the filament holder
through the dust cleaner. After a few months of printing it is recommended to replace the dust cleaners.
12.3 Motion system
The linear bearings require almost no maintenance. Recommended is that you put a little some grease on
them every 3-4 months.
The belt tension of the x and y axis can also be checked in intervals of 3 months. Check this small movie to
see how to tension the belts.
https://www.youtube.com/watch?v=dpS6nWn5rE8
Quick Start Guide FELIX Pro 3 Touch
25 January 2019
26
Page
Advertisement
Table of Contents
