Table of Contents
Advertisement
Command
EXIT or QUIT
HELP or ?
TIME
3.6.4
MCC EEPROM menu (Reserved for factory use only)
To switch to the EEPROM menu, enter EEPROM at the MCC main menu. The contents of the MPS3
board EEPROMs identify the specific board variant and might contain data to load to other devices on
the board.
Do not modify the factory-programmed EEPROM values.
The following table shows the EEPROM commands.
100765_0000_04_en
Description
Return to main menu.
Display this help.
Display current time.
Caution
Command
CONFIG 0 filename
EXIT or QUIT
ERASECON [0]
ERASEDEV [0]
ERASERANGE [0] [start] [end] Erase EEPROM between start and end.
ERASEIMAGE image_id
ERASEIMAGES
HELP or ?
READIMAGES
READCF [0]
READRANGE [0] [start] [end]
Copyright © 2017–2020 Arm Limited or its affiliates. All rights
Table 3-2 MCC debug command menu (continued)
reserved.
Non-Confidential
3 Configuration
3.6 MCC command-line interface
Table 3-3 EEPROM commands
Description
Write configuration file to EEPROM.
Return to main menu.
Erase configuration section of EEPROM.
Erase device section of EEPROM.
Erase image stored in board EEPROM.
Erase images stored in board EEPROM.
Display this help.
Read images stored in board EEPROM.
Read configuration EEPROM.
Read EEPROM between [start] and [end].
3-69
Advertisement
Table of Contents
