Table of Contents
Advertisement
3.6
MCC command-line interface
The MPS3 board command‑line interface supports system command‑line input to the MCC.
This section contains the following subsections:
•
3.6.1 Overview of the MCC command-line interface on page
•
3.6.2 MCC main command menu on page
•
3.6.3 MCC debug menu on page
•
3.6.4 MCC EEPROM menu (Reserved for factory use only) on page
3.6.1
Overview of the MCC command-line interface
You must connect a workstation to UART0 to enter system commands.
The workstation settings must be:
•
115KBaud.
•
8N1 which is 8 data bits, no parity, one stop bit.
•
No hardware or software flow control.
3.6.2
MCC main command menu
The following table shows the MPS3 board MCC main menu system commands.
Command
CAP filename[/A]
Copy input_filename_1
[input_filename_2]
output_filename
DEBUG
DEL filename
DIR [mask]
EEPROM
FILL filename [nnnn]
FORMAT [label]
HELP or ?
HELP configfile
HELP boardfile
HELP imagefile
HELP version
100765_0000_04_en
3-68.
Description
Capture serial data to the file filename.
Use the /A option to append data to an existing file.
Copy file input_filename_1 to output_filename.
Option input_filename_2 merges input_filename_1 and input_filename_2.
Change to the debug menu.
Delete file filename.
Display a list of files in the directory.
Change to the EEPROM menu.
Caution
The EEPROM menu is reserved for factory use only.
Create a file filename filled with text.
nnnn specifies the number of lines to create. The default is 1000.
Format Flash Memory Card.
Display this help.
Display config file flags
Display board file flags
Display image file flags
Display MCC version history
Copyright © 2017–2020 Arm Limited or its affiliates. All rights
reserved.
Non-Confidential
3-67.
3-67.
3-69.
Table 3-1 MCC main menu system commands
3 Configuration
3.6 MCC command-line interface
3-67
Advertisement
Table of Contents
