Table of Contents
Advertisement
The figure shows a single‑width FMC board, 69mm × 76.5mm, fitted. The maximum component height
in the shaded area in the figures is 6mm to enable fitting of wider FMC boards.
Configuration of Arm FMC expansion boards
The MPS3 board provides a custom 14‑pin connector to enable configuration of Arm FMC boards using
2
I
C, SPI, and reset signals. The configuration process is similar to the configuration process used on the
Arm Versatile Express boards that use the signals on the HDRY headers.
Arm FMC expansion boards provide a daughterboard EEPROM and a Daughterboard Configuration
Controller (DCC). The DCC and the MCC on the MPS3 board configure the Arm FMC expansion board
using the configuration information in the daughterboard EEPROM.
100765_0000_04_en
J25
J30
1
J27
1
J26
1
J29
J33
J36
1
J37
1
J35
1
J39
D5
D12
1
2
3
4
5
6
7
8
PB1 PB2
Component height in the
shaded area is 6mm
maximum, enabling fitting
of wider FMC boards.
Figure 2-23 FMC-HPC board fitted to the MPS3 board FMC-HPC expansion connector
Copyright © 2017–2020 Arm Limited or its affiliates. All rights
reserved.
Non-Confidential
LCD display and touch
screen
Xilinx Kintex
Ulstrascale KU115
FPGA
FMC-HPC
Expansion board
2 Hardware description
2.17 FMC-HPC interface
2-48
Advertisement
Table of Contents
