Table of Contents
Advertisement
Command
REBOOT
REN filename_1 filename_2
RESET
SHUTDOWN
TYPE filename
USB_ON
USB_OFF
READ_AXI filename address
end_address
WRITE_AXI filename address
3.6.3
MCC debug menu
To switch to the debug menu, enter DEBUG at the MCC main menu. The debug menu is valid only in
the run state.
The following table shows the debug commands.
Command
CFG R|W OSC|V|TEMP|SCC device [data] Read|Write SPI configuration command. For SCC, device is the register address.
CFG W DVIVGA|SVGA|XGA|SXGA|UXGA
DATE
DEBUG 0|1
DEPOSIT address_data
EXAM address [nnnn]
100765_0000_04_en
Table 3-1 MCC main menu system commands (continued)
Description
Cycle system power and reboot.
Rename a file from filename_1 to filename_2.
Reset the board using the nSRST reset signal.
Shut down the power supply but leave the MCC powered. The board returns to standby
state.
Display the contents of text file filename.
Enable MCC USB 2.0 configuration port.
Disable MCC USB 2.0 configuration port.
Read system memory to file filename from address to end_address.
Note
This command:
•
Is only ever available in run state.
•
Might not be available in your particular FPGA image.
Write file filename to system memory at address.
Note
This command:
•
Is only ever available in run state.
•
Might not be available in your particular FPGA image.
Description
Write DVI configuration command.
Display current date.
Enable or disable debug printing:
0 Disable.
1 Enable.
Write word to system memory address.
Examine system memory address at address. nnnn is number, in hex, of words to
read.
Copyright © 2017–2020 Arm Limited or its affiliates. All rights
reserved.
Non-Confidential
3.6 MCC command-line interface
Table 3-2 MCC debug command menu
3 Configuration
3-68
Advertisement
Table of Contents
