Table of Contents
Advertisement
2.17
FMC-HPC interface
The MPS3 board supports high speed, high pin count expansion using the FPGA Mezzanine Card (FMC)
standard.
Overview of the FMC-HPC interface
The MPS3 board uses the FMC
•
One 400‑way Samtec SEARAY connector.
•
160 I/O.
•
10 × high‑speed differential transceivers, Multi
•
2 × high‑speed differential clocks, MGT clocks.
•
Four differential clocks.
•
Power.
The following figure shows the MPS3 board FMC‑HPC interface.
The FMC board configuration EEPROM is part of the FMC standard. The Arm daughterboard
configuration EEPROM and Daughterboard Configuration Controller (DCC) are not part of the FMC
standard but are supplied with Arm FMC daughterboards.
FPGA-FMC pin connectivity
The FPGA-FMC pin connectivity is available in Application Note AN533 Blinky example FPGA image
for the MPS3 Prototyping Board.
The Application Note can be downloaded as a pack from:
https://developer.arm.com/tools-and-software/development-boards/fpga-prototyping-boards/download-
fpga-images.
100765_0000_04_en
‑ High Pin Count (FMC‑HPC) variant and provides:
FPGA
MPS3 FPGA Prototyping Board
Note
Copyright © 2017–2020 Arm Limited or its affiliates. All rights
Non-Confidential
‑ Gigabit Transceivers (MGTs).
FMC-HPC
400-way
connector
10 MGTs
160 I/O
Clks
Power
MCC
I
2
FMC
configuration
connector
Figure 2-22 MPS3 board FMC-HPC interface
reserved.
2 Hardware description
2.17 FMC-HPC interface
FMC-HPC
expansion board
10 MGTs
160 I/O
Clks
Power
FMC board
2
I
C
configuration
EEPROM
daughterboard
C configuration
configuration
EEPROM
SPI
DCC
Reserved
for Arm
daughterboards
Arm
2-46
Advertisement
Table of Contents
