Running The Base Reference Design - Xilinx Virtex-6 FPGA ML605 Getting Started

Running the Base Reference Design

Now that you have the ML605 set up and the Base Reference Design Application software
installed, you can run the demo. You should have the Ethernet cable connected between
the ML605 board and your PC Ethernet port.
Note:
To start the application GUI, please go to your Windows START menu and select All
Programs → XILINX → Base Reference Design → Base Reference Design Interface
The GUI shown in
X-Ref Target - Figure 1-54
You will notice in the Status field at the bottom of the GUI that the Link needs to be set.
Virtex-6 Getting Started Guide
UG533 (v1.4) November 15, 2010
Turn off any wireless cards while running this demonstration.
Figure 1-54 will start.
Figure 1-54: Network Link Setup Request
www.xilinx.com
Getting Started with the Base Reference Design
55