Table of Contents
Advertisement
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
This section is for iGSMBR communication modules only.
Running Network Diagnostics
The network diagnostic process tests the integrity of the links between the communications
module and the various connection points of AlarmNet Control that are known as
"Redirectors" (Redirs or RDR).
To initiate the network diagnostics, press the [F] key on the 7720P Programming Tool.
NOTE: The test is performed ONLY if a physical link is detected. If no physical link is
detected, the test is aborted and the following is displayed:
If a physical link is detected, the diagnostics are performed. The following shows the
progression of the test:
Testing Redir 1
Testing Redir 2
Reached Gateway
Redir 1
Service OK
Testing Redir 2
Redir 2
Service OK
Testing Redir 3
Redir 3
Service OK
Network Diagnostics
NO PHYSICAL LINK
The first step of the test traces the connection to Redir 1 at
AlarmNet Control.
A successful trace to Redir 1 is indicated here. Redir 2 is then
tested. See below for possible errors that may occur at this stage of
testing.
The service at AlarmNet Control on Redir 1 is functioning. (See
below for possible errors that may occur at this stage of testing.)
The first step of the test traces the connection to Redir 2 at
AlarmNet Control.
The service at AlarmNet Control on Redir 2 is functioning. (See
below for possible errors that may occur at this stage of testing.)
The first step of the test traces the connection to Redir 3 at
AlarmNet Control.
The service at AlarmNet Control on Redir 3 is functioning. (See
below for possible errors that may occur at this stage of testing.)
S E C T I O N
6
6-1
Advertisement
Table of Contents
