Module Supervision Features
The communications module utilizes the following types of supervision and fault detection:
Network communication failure: In the event the AlarmNet network does not hear a
supervisory message from the module within a specified time ("Supervision" option),
AlarmNet notifies the central station of a communication failure.
Communication path failure: In the event the module detects a communication path
failure, the control panel can be notified of a trouble condition with the module after a
specified time has elapsed ("Notify Panel Of" option).
Fault output: Terminal 11 can serve as a fail-safe trigger for module fault conditions.
If used, the fault relay will trip when the following conditions occur: tamper, power loss,
low battery, battery charger fault, and loss of network connectivity.
these conditions must be enabled.)
The fault relay will also trip if the module is not registered or if the module is remotely
disabled by AlarmNet.
Primary power loss and low battery reporting ("Pwr Loss Rpt", "Low Bat Rpt" options).
Cover and optional back tamper condition reporting ("Tamper Rpt" option).
Internal antenna to provide additional security to the installation by making the device
Testing the System
Refer to the control panel installation instructions for procedures to test the entire system.
For a list of control panels that are compatible with this device, go to:
From the Support & Resources tab, click MyWebTech. After logging on, enter the product
part number then click go. Under Essential Docs select Compatibility Chart.
Compatible receivers are:
Section 1: General Information
Alarm reporting for