Honeywell AlarmNet GSMBR Installation And Setup Manual page 56

Communications module
Table of Contents

Advertisement

GSMBR / iGSMBR Installation and Setup Guide
This equipment generates and uses radio frequency energy and if not installed and used
properly, in accordance with the manufacturer's instructions, it may cause interference to
radio and television reception.
If this equipment causes interference to radio or television reception, which can be
determined by turning the equipment off and on, the user should try to correct the
interference by one or more of the following measures:
If using an indoor antenna, have a quality outdoor antenna installed.
Reorient the radio or television receiving antenna until interference is reduced or
eliminated.
Move the radio or television receiver away from the communications module.
Move the radio or television antenna leads away from any communications module or
control panel wiring.
Plug the radio or television into a different outlet so that it is on a different branch
circuit from the communications module or control panel.
If necessary, the user should consult the dealer or an experienced radio/television technician
for additional suggestions.
The user shall not make any changes or modifications to the equipment unless authorized by
the Installation and Setup Guide or User Guide. Unauthorized changes or modifications
could void the user's authority to operate the equipment.
D-2
NOTICE

Advertisement

Table of Contents
loading

This manual is also suitable for:

Alarmnet igsmbr

Table of Contents