Table of Contents
Advertisement
PROMPTS
Review? Y/N
77
Setting Factory Defaults
To reset the programming options to factory-default values, press [ESC] at the "Exit Prog
Mode?" prompt.
Set Default?
Y/N_
If you press [Y], all programmed values are reset to the original factory settings. PLEASE
NOTE THAT THIS WILL ERASE ANY PASSWORD THAT MAY HAVE BEEN ENTERED.
After pressing [Y], the Create Password prompt appears (see Prompt 4).
Exiting the Programming Mode
To exit the programming mode, press [N] in response to the "Review?" prompt. Then press
[Y] to the "Exit Prog Mode?" prompt. Upon exiting, the root file is updated to log the changes
made. A message is displayed telling the user that this step is being executed. When
complete, the message "DONE" is displayed to indicate the file was successfully uploaded.
If the file is not successfully uploaded, one of the following prompts will be displayed. Follow
the steps shown below until the upload is successful.
Display
Cannot Upload
Try Again? Y/N_
Failed to Update
Root File!
Programming for Zone Trigger, 4204 and Two-4204 Modes
4204/
ZONE
ENTRY
2-4204
TRIG.
Press [Y] to reset factory default values.
Press [N] to cancel this function.
If critical configuration changes were made, such as the mode of operation, the
communications module will reset to ensure that the programming features are
enabled.
Description
Module is not yet initialized.
Network problem, or you
answered "N" to "Cannot
Upload Try Again?" prompt.
OPTIONS
only when the parameter is changed back to
"Auto Detect".
Reviewing Programming Mode Entries
[Y] = review
To review the programming options (to ensure
[N] = exit
that the correct entries have been made), press
[Y]. The programming prompts are displayed
again. Use the up/down arrow keys to scroll
through the program fields without changing
any of the values. If a value requires change,
simply type in the correct value. When the last
field is displayed, the "REVIEW?" prompt again
appears.
To exit the programming mode, press [N] in
response to the "REVIEW?" prompt, and refer to
Exiting Programming Mode below.
What to do
Wait for RSSI indicator LEDs to be lit.
Press [Y].
Initiate the Force Server Update
Command by pressing the [0] key; refer to
Section 5: Programmer Keyboard Commands.
Section 3: Programming
DESCRIPTION
3-21
Advertisement
Table of Contents
