Download Print this page

Register Using The Programming Tool - Honeywell AlarmNet GSMBR Installation And Setup Manual

Communications module
Hide thumbs

Advertisement

GSMBR / iGSMBR Installation and Setup Guide

Register using the Programming Tool

The interactive registration feature allows the installer to register the module through a
series of keyboard commands on the 7720P Programming Tool. This method of registration
lets the installer monitor the registration process.
Registering ...
Registration
SUCCESS
Possible Errors
Registration BAD
Timed Out
Registration BAD
Pri Sub ID BAD
Registration BAD
nd
2
Sub ID BAD
Registration BAD
Pri&Sec – IDs BAD
Registration BAD
Pri ID – Need PIN
Registration BAD
nd
2
ID – Need PIN
Registration BAD
nd
Pri&2
4-2
Once the installation is complete, press the [Shift] and the up arrow
[ ] key. The registration message is sent and the unit waits for the
acknowledgment.
If this is a new installation and the city, central station, and
customer numbers have been correctly entered, the module is
registered and this message is displayed.
The communications module is now in full service and
available for alarm reporting to the central station.
Displayed if no response to the registration request is received.
Indicates the city, central station, or customer number for the labeled
account(s) is not accepted. The ID information was either entered
incorrectly, or the central station failed to pre-authorize programmed
ID numbers with AlarmNet customer service.
Indicates the city, central station, or customer number for the
Secondary account is not accepted. The ID information was either
entered incorrectly, or the central station failed to pre-authorize
programmed ID numbers with AlarmNet customer service.
Displayed when both primary and secondary subscriber IDs are
invalid.
Displayed if this is a repair/replacement, or an error was made in
programming the Primary account information for an existing
account. This prompt appears for 2 seconds. See the Replacing an
existing module section below for further displays.
This prompt is displayed if this is a repair/replacement, or an error
was made in programming the Secondary account information for an
existing account. This prompt appears for 2 seconds. See the
Replacing an existing module section below for further displays.
This prompt is displayed if this is a repair/replacement, or an error
was made in programming BOTH the Primary and Secondary
– Need PIN
account information for an existing account. This prompt appears for
2 seconds. See the Replacing an existing module section below for
further displays.

Advertisement

loading

  Related Manuals for Honeywell AlarmNet GSMBR

This manual is also suitable for:

Alarmnet igsmbr