Download Print this page

Appendix B: Uploading And Downloading Of Panel Data - Honeywell AlarmNet GSMBR Installation And Setup Manual

Communications module
Hide thumbs

Advertisement

Appendix B: Uploading and Downloading of
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
The communications module can be used to upload or download data to Honeywell's VISTA
and LYNXR-I control panels. This enables local site maintenance that is independent of the
central station. In addition, it enables modification to sites globally via the internet.
Some control panels support uploading/downloading of data using the ECP bus, and some
must use the Direct Wire method.
For control panels that support uploading/downloading of data via the ECP bus, no further
connections to the communications module is necessary.
For control panels that do not support uploading/downloading of data via the ECP bus, a
Direct Wire connection (using the trigger cable) is used.
Direct Wire Setup
To utilize a Direct Wire connection, this option must be enabled (Direct Wire Y/N) in the
control panel's programming, and the ECP device address for the communications module
must be entered as a keypad.
Additionally, the communications module must be connected to the control panel by a cable
as shown below.
NOTES:
For Direct Wire downloading on Commercial Fire panels (such as; VISTA-128FBP,
FA1700C), set program field 3 19 to [1]. This enables J2 for RS-232 serial data.
This feature is not available if the communications device is set for zone trigger mode.
FA1660C J8 CONNECTOR
1
2
PARTS SUPPLIED WITH DOWNLOADER KIT P/N VBPCOMKIT
VISTA-128BP/250BP
3
4
5
6
7
8
NU
9
PROGRAMMER
WHITE
BLUE
K4668WH
RJ 11 CABLE
4142 TR CABLE
Panel Data
COMMUNICATIONS MODULE
OR EXTERNAL ANTENNA
PORT
50 OHM, MMCX ONLY
TB 1
Honeywell
1
2
3
4
5
6
7
8
9
10
11
B-1

Advertisement

loading

  Related Manuals for Honeywell AlarmNet GSMBR

This manual is also suitable for:

Alarmnet igsmbr