Download Print this page

Internet Connectivity Displays (Igsmbr Only) - Honeywell AlarmNet GSMBR Installation And Setup Manual

Communications module
Hide thumbs

Advertisement

GSMBR / iGSMBR Installation and Setup Guide
[0]
[ENTER]

Internet Connectivity Displays (iGSMBR only)

[D]
[F]
5-4
Force Server Update?
Y/N
Strt Prog Mode?
Y/N_
Physical Link
Good/Bad
NIC IP Address
xxx.xxx.xxx.xxx
Subnet Mask
xxx.xxx.xxx.xxx
Gateway IP Addr
xxx.xxx.xxx.xxx
DNS Serv IP
xxx.xxx.xxx.xxx
Encryption Test
AES Passed!
DHCP
OK
Testing Gateway
Redir 1
Force Upload of Configuration File to Server
Pressing [Y] will force the device to upload its entire
configuration file to the server.
Pressing [N] cancels the operation.
NOTE: If the internet is not available, and the
module is not initialized, when you enter this
command, the following screen will be displayed:
Cannot Upload
Try Later! _
Wait for the RSSI LEDs to light, indicating the
module has completed its initialization, and try again.
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].
Network Diagnostics Display
Indicates whether the device has detected a physical
connection to the internet.
Press the [Space] key to go to the next field.
IP Information Display
Displays the IP address assigned to this device.
Press the [Space] key to go to the next field.
Displays the 32-bit address mask used to indicate the
portion (bits) of the IP address that is being used for
the subnet address.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
Displays the IP address assigned to the Gateway.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
Displays the IP address assigned to the DNS (Domain
Name System) server.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
Performs a self-test of the AES encryption algorithm.
Press the [Space] key to go to the next field.
Press the backspace [BS] key to go to the previous field.
DHCP (Dynamic Host Configuration Protocol) indicates
server is performing satisfactorily.
Press the [Space] key to go to the Physical Link display.
Run Network Diagnostic Test
Performs a set of network diagnostics that tests the
integrity of the links between the communications
module and the various connection points (Redirs) to
AlarmNet. Refer to Section 6: Network Diagnostics.

Advertisement

loading

  Related Manuals for Honeywell AlarmNet GSMBR

This manual is also suitable for:

Alarmnet igsmbr