Exiting Programming Mode; Setting Factory Defaults - Honeywell AlarmNet 7847i-E Installation And Setup Manual

7847i/7847i-E Installation and Setup Guide
PROMPTS
DNS Serv IP Addr:
77
255.255.255.255_
NOTE: The "Enable Pwr Save" option is not available, and is not displayed, if Private LAN is enabled on the 7847i-E.
Enable Pwr Save
78
(Y)_
Review? Y/N
79

Exiting Programming Mode

To exit the programming mode, press [N] in response to the "REVIEW?" question. Then
press [Y] to the "Exit Prog Mode?" question. Upon exiting, the root file is updated to log the
changes made. A message is displayed telling the user that this step is being executed.
When complete, the message "DONE" is displayed to indicate the file was successfully
uploaded.
If critical configuration changes were made, such as the mode of operation, the 7847i/7847i-E will
reset to ensure that the programmed features are enabled.

Setting Factory Defaults

To reset the programming options to factory-default values, press [ESC] at the "Exit Prog
Mode?" prompt.
Set Default?
Y/N_
If you press [Y], all programmed values are reset to the original factory settings. PLEASE
NOTE THAT THIS WILL ERASE ANY PASSWORD THAT MAY HAVE BEEN ENTERED.
After pressing [Y], the Create Password prompt appears (see Prompt 4).
3-20
4204/
ZONE
ENTRY
2-4204
TRIG.
✔ ✔
✔ ✔
✔ ✔
Press [Y] to reset factory default values.
Press [N] to cancel this function.
OPTIONS
12 digit: Enter the 4-part IP address assigned to the DNS
xxx.xxx.xxx.xxx (Domain Name System) server. The four parts of
[0.0.0.0.] = not
the address must be separated by spaces
used
(displayed as periods in Review mode).
[Y], [N] For 24 hour UL Battery Backup requirement,
this feature must be enabled, or the unit must be
powered by an appropriate UL listed UPS. If
connectivity problems occur with certain routers
or switches disable this option.
This option is forced to [N] when Private LAN is
enabled.
Reviewing Programming Mode Entries
[Y] = review
To review the programming options (to ensure
[N] = exit
that the correct entries have been made), press
[Y]. The programming questions are displayed
again. Use the up/down arrow keys to scroll
through the program fields without changing
any of the values. If a value requires change,
simply type in the correct value. When the last
field is displayed, the "REVIEW?" question again
appears.
To exit the programming mode, press [N] in
response to the "REVIEW?" question, and refer
to Exiting Programming Mode below.
DESCRIPTION