Table of Contents
Advertisement
Bennett Horizon 2.1 Series Installation Manual
Determining the Number of Product Supply Pipes Needed
Determine the dispenser's model number from the serial tag located on side 1 inside the unit on the deck. Locate the
model number in the table below to determine the number of product pipes required.
Step 1 Determine the type of supply line needed from the model number's 10
2412FS-2XXR (Note the R) the dispenser will require a submerged pump and pressurized supply line for each
product. If the model number is 2412FS-2XXS (Note the S) the pump will require a suction supply line for
each product.
Step 2
Determine the number of product pipes required by finding the model number below. Note: The use of X
in the model number indicates a field where the entry in not important to this discussion.
Model Number (Side 1 or Side 2)
2422FS-1XXXX
2424FS-2XXXX
2433FS-1XXXX
2436FS-2XXXX
2444FS-1XXXX
2448FS-2XXXX
Determining the Correct Position of the Product Supply Pipes
The following chart indicates the relationship of the product inlets to the nozzle boots. Find the model number of the
dispenser you are installing and determine the number of product inlets and their location. Exact inlet locations can
be found on the base diagrams (footprints) later in this manual. Note: UL Listed ethanol equipment must be used if
an alternative fuel product is being dispensed.
Introduction
Product Supply Lines Required
Use 1 product line plumbed to position A
Use 1 product line plumbed to position D
Use 1 product line plumbed to position A
Use 1 product line plumbed to position B
Use 1 product line plumbed to position D
Use 1 product line plumbed to position A
Use 1 product line plumbed to position B
Use 1 product line plumbed to position C
Use 1 product line plumbed to position D
Figure 2 - Product Supply Positions
4
Introduction
th
position. If the model number is
Advertisement
Table of Contents
