Determining The Model Number - Bennett 3000 Series Service Manual

Determining the Model Number

Determine the model number of the dispenser from the serial plate located on the dispenser. Utilizing
the chart below determine the features of the dispenser to be installed. Understanding the features of
the dispenser to be installed will be helpful in understanding the proper installation of the dispenser.
How a Model for the 3700 Series Dispensers is Made Up.
Pump Mod-
el Retail Commercial
3711 X
3712 X
3722
3724 X
Note 1 - Flow Rate -
Standard - *23gpm (Remote) , 15 gpm (Self Contained)
Heavy Duty Suction - 24 gpm
Little Squirt - 35 gpm (nominal with one hose active, 40 gpm total with Master and Satellite in
simultaneous flow ) with 1" valve (remote or suction).
Big Squirt - 35 gpm (nominal with one hose active, 60 gpm total with Master and Satellite in
simultaneous flow) with 1-1/2" valve (remote only).
*Flow rates are "nominal" (under ideal test conditions without accounting for system restrictions
such as hanging hardware. Actual flow rates will vary depending on conditions of installation.
Note 2 - Motor -The hydraulic arrangement can be as follows-
Remote (submerged pump)
Suction with Standard 1 phase 115/230 VAC 50/60 Hz.
Suction with 1 phase 115/230 VAC 50/60 Hz with prepay valves.
Suction with 3 phase 380 VAC 50 HZ.
Suction with 3 phase 380 VAC with pre-pay valves.
Electronics
531 Package
531
X
531
531
8
Flow Rate # Products
See Note 1
All 1
All 1
All 2
All 2
107932 Rev G 4-24-17
# Hoses Motor
See Note 2
1
2
2
4