Determining The Model Number - Bennett 3000 Series Service Manual

Determining the Model Number

Determine the model number of the dispenser from the serial plate located on the dispenser. Utilizing
the chart below determine the features of the dispenser to be installed. Understanding the features of
the dispenser to be installed will be helpful in understanding the proper installation of the dispenser.
How a Model for the 3700 Series Dispensers is Made Up.
Pump
Retail Commercial
Model
3711 X
3712 X
3722 X
3724 X
3811 X
3812 X
3822 X
3824 X
Note 1 - Flow Rate -
Standard - *23gpm (Remote) , 15 gpm (Self Contained)
Heavy Duty Suction - 24 gpm
Little Squirt - 35 gpm (nominal with one hose active, 40 gpm total with Master and Satellite in
simultaneous flow ) with 1" valve (remote or suction)
Big Squirt - 35 gpm (nominal with one hose active, 60 gpm total with Master and Satellite in
simultaneous flow) with 1-1/2" valve (remote only)
*Flow rates are "nominal" (under ideal test conditions without accounting for system restrictions
such as hanging hardware. Actual flow rates will vary depending on conditions of installation.
Note 2 - Motor -The hydraulic arrangement can be as follows-
Remote (submerged pump),
Suction with Standard 1 phase 115/230 v.a.c. 50/60 Hz,
Suction with 1 phase 115/230 v.a.c. 50/60 Hz with prepay valves,
Suction with 3 phase 380 v.a.c. 50 HZ,
Suction with 3 phase 380 v.a.c. with pre-pay valves
Electronics Flow Rate
See Note 1
531 Package All
531 All
531 All
531 All
210 Package All
210 All
210 All
210 All
8
Motor
# Products # Hoses
See Note 2
1 1
1 2
2 2
2 4
See Note 2
1 1
1 2
2 2
2 4
107933 Rev E 03/01/11